RP-4

The RP-4 is a full-blown four-shelf taller platform. It can also use the Rhythm extra-large turntable shelf, hence becoming the one rack that services the system. When space is a premium this multi-shelf platform retains all the qualities associated with the lower profile designs. 

The RP-4 will weigh approximately 180 pounds set up without the components so moving it becomes a challenge without assistance.

This model can also be purchased as a five (5) shelf version.

Rod Lengths:

Rhythm Rod- 7.0-Multi Support Rods for Rhythm Platforms up to 4.20 Inches of Component Space using 2.5″ Audio Points and APCD4 Coupling Discs WITH 2″ of Space between the component and the next shelf. (See legend for smaller Audio Points available spacing)   RR-ROD-7.0-MULTI

Rhythm Rod-9.75-Multi Support Rods for Rhythm Platforms up to 6.95 Inches of Component Space using 2.5″ Audio Points and APCD4 Coupling Discs WITH 2″ of Space between the component and the next shelf. (See legend for smaller Audio Points available space)  RR-ROD-9.75-MULTI

Rhythm Rod-12.75-Multi Support Rods for Rhythm Platforms up to 9.95 Inches of Component Space using 2.5″ Audio Points and APCD4 Coupling Discs WITH 2″ of Space between the component and the next shelf. (See legend for smaller Audio Points available spacing)  RR-ROD-12.75-MULTI

Equipment weight is never an issue as all Rhythm Platforms function with a few ounces of weight up to one ton of mass.

Component Chassis Height should be measured from bottom to top of the chassis only – Do NOT measure component factory-installed footer systems as these additional heights will have no bearing on chassis height requirements. 

If you require a higher rod height, please call customer service for pricing.

Optional Purchase: Add a Fourth 2.5 Inch Audio Point, APCD4 Coupling Disc, and AP-TB-HND-1A.5 Turning Bolt Package to any shelf. Additional Audio Points increase overall performance on any component or loudspeaker. Note: Leveling may become an issue using a four-point bearing system due to warped equipment chassis or speaker enclosures. In order to level use BW-1.5-2.0W Leveling Washers.